skullbrain.org
http://skullbrain.org/legacy/

SB suits on Obitsu.
http://skullbrain.org/legacy/viewtopic.php?f=3&t=5193		 Page 1 of 1
Author:  moriachi [ Wed Sep 20, 2006 11:30 pm ]
Post subject:  SB suits on Obitsu.
Ok, so I am looking to put Secret Base suits on Obitsu bodies. All fit fine except the inner heads. The neck post that comes with the Obitsu body is slightly smaller or about the same size as the hole in the inner head is so it sits very very loose and comes off straight away with any pressure or sags with the outer heads put on.

There is another neck post that is pre-inserted in the body when you get it in the pack that is just a flat cylinder. This is a tight fit and could work.

Any ideas or success stories out there? I don't have nearly enough Henshins and am unlikely to get as many as I need anyway.
Author:  Parka [ Thu Sep 21, 2006 12:36 am ]
Post subject: 
before Geo went radio rental he had a bee suit on an obitsu. Not sure the method he used. You could try bugging him on roto?
Author:  Anti Social Andy [ Thu Sep 21, 2006 2:25 am ]
Post subject: 
Parka wrote:
before Geo went radio rental he had a bee suit on an obitsu. Not sure the method he used. You could try bugging him on roto?


Mebbes warn Kirby about the annual meltdown while you're over there! :wink:
Author:  dr_tongues_toys [ Thu Sep 21, 2006 8:10 am ]
Post subject: 
He's BACK............http://www.skullbrain.org/bb/viewtopic.php?t=5196
Author:  moriachi [ Thu Sep 21, 2006 3:56 pm ]
Post subject: 
The suits themselves seem to fit fine with a little bit of jiggling, but the neck post is the problem. The Skulltoys suits have been designed with this is mind, but the SB suits are designed specifically for the Henshin.

Geo, you find a way round this with your Phantom 8 suit? Or you just got the heads sitting in position?
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/