| skullbrain.org http://skullbrain.org/legacy/ |
|
| Sculpey question http://skullbrain.org/legacy/viewtopic.php?f=49&t=30514 |
Page 1 of 1 |
| Author: | Rich [ Mon Jun 22, 2009 6:26 pm ] |
| Post subject: | Sculpey question |
I have read that you can bake and then rebake sculpey with no issues as long as you bake it at the same temp. I have something I want to bake before I go to the next step as it will help keep the project clean. Has anyone here done this and if so what did you find ? |
|
| Author: | Grapefruit Goblin [ Mon Jun 22, 2009 10:38 pm ] |
| Post subject: | Re: Sculpey question |
You kinda have to go through some trial and error tests with the stuff. You can rebake it but I have had some pieces burn. make a piece the same mass as what you want and experiment on that. |
|
| Author: | uh oh [ Tue Jun 23, 2009 1:44 pm ] |
| Post subject: | Re: Sculpey question |
I re-bake it all the time with no problems. Occasionally I'll forget about it in the oven and it will burn but that's just cosmetic. It bakes at such a low temp that it makes little difference. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|