I used ink, Tamiya, and Createx. I don't remember who made the brush - I bought it as a package with a compressor. Pretty cheap, but I was hoping it would do what I needed it to do. It is a dual action.
I think I might file the tip of the needle to make sure it's not bent. Ya see, when I first got it I took it apart to see how it all worked. But putting it back together was a I FART A LOT! But it worked fine the first couple times I used it. I think I just didn't clean it out well enough. And talking to someone else it sounds like I may not have thinned my paint enough - so maybe that's what's been causing it to spit.
Anyway, I figure I'll bombard it with thinner and see if that helps...and then thin my paints more!

I used ink, Tamiya, and Createx. I don't remember who made the brush - I bought it as a package with a compressor. Pretty cheap, but I was hoping it would do what I needed it to do. It is a dual action.
I think I might file the tip of the needle to make sure it's not bent. Ya see, when I first got it I took it apart to see how it all worked. But putting it back together was a I FART A LOT! But it worked fine the first couple times I used it. I think I just didn't clean it out well enough. And talking to someone else it sounds like I may not have thinned my paint enough - so maybe that's what's been causing it to spit.
Anyway, I figure I'll bombard it with thinner and see if that helps...and then thin my paints more!

Step 1: How to Mask: